To Next PageTo Next Page
Need help?Do you have a question about the Onkyo TX-DS797 and is the answer not in the manual?
General| Type | AV Receiver |
|---|---|
| Channels | 7.1 |
| THX Certified | Yes |
| Total Harmonic Distortion (THD) | 0.08% |
| Input Sensitivity | 200 mV |
| Surround Sound Modes | Dolby Digital, DTS, THX Surround EX |
| Amplifier Type | Discrete |
| Speaker Impedance | 8 ohms |
| Power Output | 100W per channel (8 ohms, 20Hz-20kHz, 0.08% THD) |
| Signal-to-Noise Ratio | 100 dB |
| Digital Audio Inputs | Optical, Coaxial |
| Component Video Inputs | 2 |
| Digital Inputs | 5 |
Technical details for power output, distortion, damping factor, and input sensitivity.
Technical details for FM and AM tuning range, sensitivity, and signal-to-noise ratio.
Power supply, consumption, dimensions, and weight of the AV receiver.
Specifications for the remote controller's transmitter, signal range, and power supply.
Procedure for replacing fuses, emphasizing using the correct type and rating.
How to reset the unit to factory settings to resolve abnormal operations.
Safety checks, including insulating resistance tests, required before customer release.
Explanation of the unit's battery-less memory preservation system.
Instructions for setting the voltage selector to match the local power supply.
Detailed steps for adjusting idling current for front, center, and surround channels.
Confirms speaker relay operation during power on/off and DC detection.
Steps to confirm speaker relay behavior based on load conditions.
Checks fan speed operation under different signal and resistor conditions.
Details on entering and using various test modes for the FL display tube.
Confirms voltage sensor operation and speaker relay behavior in specific test modes.
