Onkyo TX-NR1010

Advanced Operations
En-84
Connecting the Zone Speakers to an
Additional Amplifier
This setup allows 7.2-channel playback in your main
listening room and 2-channel stereo playback in Zone 2/3.
Note
• The volume of Zone 2/3 must be set on the Zone 2/3 amplifier.
12V Trigger Out
When Zone 2/3 is turned on, the output from the 12V
TRIGGER OUT jack goes high (+12 V and max. 150 mA
for Zone 2, +12 V and max. 25 mA for Zone 3).
Connecting this jack to a 12-volt trigger input on a
component in Zone 2/3 will make that component turn on
or off as the AV receiver turns on or off the Zone 2/3.
Zone 2 Video Output
The AV receiver allows you to enjoy the composite video
and HDMI audio/video in Zone 2 by connecting the TV of
Zone 2 to the respective output jacks.
Note
• If you use HDMI OUT ZONE 2, make sure to set “Zone 2
HDMI” to “Use” (➔ page 60)
• Video and audio signals from an HDMI input will be output to
HDMI OUT ZONE 2.
•The ZONE 2 OUT V jack outputs video of components con-
nected to composite video only.
• The information of connected component appears on a TV in
Zone 2 by pressing DISPLAY.
R
L
IN
R
L
IN
Main room
TV
Zone 2
AV receiver
Receiver/
integrated amp
Receiver/
integrated amp
Zone 3
The on-screen information appears on the TV screen
in Zone 2 by connecting the TV to HDMI OUT
ZONE 2 of the AV receiver with HDMI cable.
Main room
TV
Zone 2
AV receiver
TV
or