TX-NR3010
SERVICE PROCEDURE-2
1 .04 / 1 2 7 1 2 A H
DISPLAY
ON/STANDBY
(TONE) (TONE)
<e.g.>
1 . 0 4 / 1 2 7 1 2 A H
1 . 0 3 / 1 2 7 0 9 A H A
1 . 0 0 / 1 2 5 3 1 a H A
1 . 0 1 / 1 2 5 2 8 A E O
(TONE)
(TONE)
<e.g.>
(TONE)
(TONE)
1 . 0 2 / 1 2 7 1 8 A H
1 . 0 0 / 1 2 2 0 7 A
(TONE)
(TONE)
(TONE)
(TONE)
(TONE)
(TONE)
(TONE)
(TONE)
4. To check version of each Firmware
5. Push ON/STANDBY (Power Off).
1. During the POWER ON, please push ON/STANDBY button while pushing down DISPLAY button.
2. The version of main multiprocessor is displayed at FL tube (only 3 seconds).
3. While the version of main microprocessor is displaying, please push (TONE) + button.
4. FL tube displays by rotation as follows.
Main Microprocessor
1st DSP/ NET
HDMI/Video Microprocessor
VSP (Video Signal Processor)
Version displayed
only for 3 seconds.
2nd DSP
OSD (On Screen Display)
To Next Page
Loading...
