TX-NR3010
SERVICE PROCEDURE-3
PRIMARY
Resistor
--- Side-B ---
Top
5. Notes on repairs (Power supply board)
Some parts on BAPS-0890 may remain high voltages
even after the power cord is disconnected from AC power source.
Before starting repair and any other work , please discharge C9002 by connecting resistors between its terminals. See the figure below
(recommended resistor spec: 5 k ohms/ 10W)
It is dangerous to touch the "PRIMARY" area surrounded by white lines without discharging.
U0063
POWER SUPPLY(PRI) PC BOARD ASS'Y
BAPS-0890
To Next Page
Loading...
