Onkyo TX-NR3010S - Debug Mode-1; Audio Debug Mode

TX-NR717/818/1010/3010/5010
DEBUG MODE-1
AUDIO DEBUG MODE-1/4
To set in Debug mode
1. Press and hold down DISPLAY button, then press ON/STANDBY button.
The version number of microprocessor is displayed
only for 3 seconds.
The version number of DSP is displayed
only for 3 seconds.
AUDIO DEBUG MODE (Display mode of the audio information)
The operations of DSP and DIR etc are able to checked by the information displayed on FL in this debug mode.
This information will help to analysing digital audio no sound trouble.
Audio dubug mode
Step-1
Exit
e.g.
TX-NR717 TX-NR818/1010/3010/5010
ON/STANDBY + (TONE)
DISPLAY
ON/STANDBY
+ (TONE)
DISPLAY
M a i n :
1 . 0 2 / 1 2 6 1 1 A H
2. Press + (TONE) button while the version number of microprocessor is displayed.
3. Press DISPLAY button while the version number of DSP is displayed.
D S P 1 s t / N E T :
1 . 0 2 / 1 2 6 0 8 A H A
e.g.
0 A 0 0 0 2 : : 0 0
A N A : o : N O N : :
4. Press DISPLAY button.
S P 0 0 F
*
0 0 F 0 0 4 0 9
4 8 4 8 2 5 6 S T B
2 : o : P C M : P C M
0 0 : x : F : O F F
1 : A N A 0 4 8 k 0 4 8 k
2 / 0 . 0 : 2 . 0 : 3 / 4
9. Press DISPLAY button.
8. Press DISPLAY button.
6. Press DISPLAY button.
5. Press DISPLAY button.
11. Press DISPLAY button.
12. Press DISPLAY button.
10. Press DISPLAY button.
7. Press DISPLAY button.
13. Press DISPLAY button.
L W : 0 0
R W : 0 0
L B : 0 0
R B : 0 0
L H : 0 0
R H : 0 0
L S : 0 0
R S : 0 0
C : 0 0
L : 0 0
R : 0 0
S W : 0 0
S W 2 : 0 0
Step-2
Step-11
Step-10
Step-9
Step-8
Step-7
Step-6
Step-5
Step-4
Step-3
14. Press DISPLAY button.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.