TX-NR525/ 626/ 727/ HT-RC550/ 560/ DTR-30.5/ 40.5
DEBUG MODE-1
AUDIO DEBUG MODE-1/5
To set in Debug mode
1. Press twice the ON/ STANDBY key while pressing the DISPLAY key.
2. Press + (TONE) button while the version number of microprocessor is displayed.
3. Press DISPLAY button while the version number of DSP is displayed.
D1.02/13202AEA
M1.01/13204ALN
AUDIO dubug mode
The status of DSP and DIR etc
will be displayed.
0A0002:__:00__
e.g.
The version number of Microprocessor is displayed
only for 3 seconds.
The version number of DSP is displayed
only for 3 seconds.
The operations of DSP and DIR etc are able to checked by the information displayed on FL in this debug mode.
This information will help to analysing digital audio no sound trouble.
Exit
e.g.
ANA:o:NON:C:__
1:ANA_048k048k
2/0.0:_2.0:3/4
2:o:PCM_:PCM__
_00:x:F:OFF___
SP00F_00F00409
_48_48256STB__
e.g.
Step-1
Step-8
Step-7
Step-6
Step-5
Step-4
Step-3
Step-2
L :0000 0000
SW :0000 0000
4. Proceed to the next step by pressing the DISPLAY key.
To Next Page
Loading...
