Onkyo TX-NR807 - Page 2

En-2
TX-NR807 allows you to update firmware using
Network connection on rear panel.
Notice:
1. Make sure your AV receiver and TV are turned
on and Ethernet cable is connected to rear panel
of the AV receiver.
2. Never unplug or turn off the AV receiver during
updating process.
3. It will take 15 to 25 minutes to update the
firmware.
4. The AV receiver will retain all your settings
after update is finished.
Step1:
Push [RECEIVER] followed by [SETUP] on the
remote controller.
Main menu will be displayed on TV screen.
Step2:
Go to “7. Hardware Setup” menu.
Step3:
Go to “7-6. Firmware Update” menu.
Note that the Firmware Update option will be grayed
out for 30 seconds after AV receiver is turned on.
Please wait.
Step4:
Select “Via NET” and push [ENTER].
Step5:
Select “Update” and push [ENTER].
Updating will begin.
Step6:
After about 15 to 25 minutes, message
“OK:Sum = ********” appears on the front display of
the AV receiver, indicating that the update has been
completed. (Alpha-numeric characters on the front
display are denoted by asterisks.)
Step7:
Using the [ON/STANDBY] button on the front panel,
turn off and on the AV receiver.
Do not use the [ON] or [STANDBY] button on the
remote controller.
Congratulations!! Now you have the latest firmware
on your Onkyo AV receiver.
(Go to the next page for troubleshooting.)
Firmware Update Procedure