102
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
be output only when it is an analog or 2ch PCM audio signal. When the AV
component is connected to this unit with an HDMI cable, digital coaxial cable
or digital optical cable, change the audio output of the AV component to the
PCM output.
• When video and audio via HDMI input are output to ZONE 2, set "1. Input/
Output Assign" - "TV Out / OSD" - "Zone2 HDMI" ( p127) to "Use" on the
Setup menu.
• For ZONE 3 output, audio from externally connected AV components can be
output only when it is an analog audio signal.
• DSD and Dolby TrueHD audio signals cannot be output to ZONE 2/ZONE 3
when selected with the "NET" input selector.
• If ZONE 2/ZONE 3 is on, power consumption during standby will increase.
• If ZONE 2 is turned on when the Pure Audio listening mode is selected in the
main room , the mode will automatically switch to the Direct listening mode.
(European, Australian and Asian models)
To set the function to o: Press while the remote controller is in the ZONE
control mode.
To Next Page
Loading...
