Onkyo TX-SR501 - Page 16

Connecting Your AV Components--Continued
Video Connections
• Using CompositeVideo
Use a composite video cable to connect the TX-SR501/
TX-SR501E's VIDEO VIDEO 2 IN to the composite video
output on your satellite/cable tuner, LD player, etc., as
shown.
• Your TV must also be connected via composite video.
iii!iiii ! ii iii!!iiii:!i!ii !!i iiii ii iii!iii i'
Satellite/cable tuner, LD player, etc. __((
E !
• Using S-Video
Use an S-Video cable to connect the TX-SR501/
TX-SR501E's S VIDEO VIDEO 2 IN to the S-Video output
on your satellite/cable tuner, LD player, etc., as shown.
• Your TV must also be connected via S-Video.
Satellite/cable tuner, LD player, etc.
• Using ComponentVideo
Use a component video cable to connect the TX-SR501/
TX-SR501E's COMPONENT VIDEO 1/2/3 IN connectors
to the component video outputs on your satellite/cable tuner,
LD player, etc., as showm
• Your TV must also be connected via component video.
Y
PB
PR
COMPONENT
VIDEO OUT
Y
PB
Satellite/cable tuner, LD player, etc.
I 'ooool
Audio Connections
• Using Coaxial or Optical Connections
• Use a coaxial digital audio cable to connect the TX-SR501/
TX-SR501E's COAXIAL DIGITAL INPUT to the coaxial
output on your satellite/cable tuner, LD player, etc., as
shown.
OR
• Use an optical digital audio cable to connect the
TX-SR501/TX-SR501E's OPTICAL 2 DIGITAL INPUT
to the optical output on your satellite/cable tuner, LD
player, etc., as showm
_- Connect one or the ether
Satellitelcable tuner, _
LD player, etc. I_ _ _ O®°°1
Initially, the VIDEO 2 input source is assigned to OPTICAL
2. If you connect to different audio input, you'll need to
assign that input to the VIDEO 2 input source (see page 24).
• Using Analog Connections
if your satellite/cable tuner, LD player, etc., doesn't have dig-
ital audio outputs, or you want to record from it, you'll need
to make the following analog connections.
Use an RCA/phono audio cable to connect the TX-SR501/
TX-SR501E's L/R VIDEO 2 IN connectors to the analog
audio outputs on your satellile/cable tuner, LD player, etc., as
shown.
Satellite/cable tuner, LD player, etc.
0ooo
Note:
To connect the TX-SR50I/TX-SR501E to a LD player's
AC-3RF output, you need a commercially available demod-
ulato_
16