To Next PageTo Next Page
Need help?Do you have a question about the Onkyo TX-SR601 and is the answer not in the manual?
General| Channels | 6.1 |
|---|---|
| Frequency Response | 10 Hz-100 kHz (+1 dB, -3 dB) |
| Total Harmonic Distortion | 0.08% |
| Type | AV Receiver |
| Digital inputs | 2 Optical, 1 Coaxial |
| Power Output | 85 W per channel (8 ohms, 20 Hz-20 kHz, 0.08% THD) |
| Input Sensitivity/Impedance | 200 mV/47 kΩ |
| Signal-to-Noise Ratio | 100 dB |
| Tuner Frequency Range | FM: 87.5 MHz-108 MHz, AM: 522 kHz-1611 kHz |
| Video Connections | Composite, S-Video |
| Output Power | 85 W per channel (8 ohms, 20 Hz-20 kHz, 0.08% THD) |
| Speaker Impedance | 6-16 ohms |
How to use buttons for receiver and other device control.
Labels for antenna, component video, R/I remote control, trigger, speakers, and AC outlets.
Recommended placement for front, center, and surround speakers.
Procedures for powering the unit on using the front panel switches.
How to turn the unit on and off using the remote control.
Specific settings for subwoofer, front L/R, center, surround L/R, and surround back speakers.
Setting the crossover frequency for bass management based on speaker size.
How to measure and input speaker distances in feet or meters.
Specific instructions for setting speaker distances on the TX-SR601/601E model.
Adjusting speaker output levels using pink noise for optimal sound balance.
Detailed steps for speaker level calibration using the remote controller.
Steps for selecting input sources and adjusting volume using the remote.
Choosing between Auto, Multich, and Analog audio input modes.
Steps for playing 5.1-channel audio from DVD players.
Using front panel or remote buttons to select modes like Direct, Stereo, Surround, THX.
Using front panel or remote buttons to select modes like Direct, Stereo, Surround.
Choosing the input source to configure settings for.
Assigning digital input jacks (OPT1, OPT2, COAX) to specific input sources.
Assigning component video inputs to sources like DVD and VIDEO.
Adjusting volume levels automatically for different input sources.
Accessing and understanding settings like Surr/Zone 2, IR IN Position, and TV Format.
Configuring surround back speakers, Zone 2 operation, and IR input position.
Adjusting low and mid-frequency response and enhancing bass with subwoofer.
Adjusting center channel prominence and stereo image expansion.
Troubleshooting steps for no power, no sound, or immediate power off.
Diagnosing problems like no sound from speakers, low subwoofer volume, or tuner reception issues.
Solving problems with the remote controller, video/audio sync, and OSD display.
Addressing issues with Late Night function, digital sources, and remote zone operation.
Explanations for common on-screen messages and their solutions.
Steps to reset the surround mode and other settings to factory defaults.
