Connecting the power
Diagram for TX-SR701/701E
(USA and Canadian models and Australian models)
STANDBY/ON
STANDBY indicator
....FE l
®@_J
/
To wall outlet
Diagram for RC-533M
(All models other than USA and Canadian models and
Australian models)
STANDBY,O.. . STANO Z
STANDBY indicator RCVR
MODE _
/@@@
i' '
PowEB L..._, Towa,ou,,o,
• Turning on the power ]nay cause a momentary power surge,
which might interfere with other electrical equipment on the
same circuit, such as computers. If this happens, use a wall
outlet on a different circuit.
(All models other than USA and Canadian models and
Australian models)
• The TX-SR701/701 E/601/601E is shipped with the main power
(POWER) switch in the on position (..i ON). When the power
cord is plugged in for the first time, the TX-SR701/701E/601/
601E will automatically enler the standby state and the
STANDBY indicator will light (same condition after step 2
below).
Turning on the power
1. Plug the power cord into an AC wall outlet.
(USA and Canadian models and Australian models)
The STANDBY indicator will light up.
(All models other than USA and Canadian models and
Australian models)
Press the POWER switch to set the TX-SR701/70IE/
601/601E to standby state.
The STANDBY indicator will light up.
o_
2. Press the STANDBY/ON button to turn on the TX-
SR701/701 E/601/601 E.
The display will light up and the STANDBY indicator will turn off.
If you press the STANDBY/ON button again, the receiver
returns to standby state.
6m
Turn off
_1
I Turning on the from the remote controller I
I
power
i
Before you can use the remole controller, you must perform slep I
above and place the TX-SR701/701 E/601/601E in the standby state.
1. Press the RCVR MODE button.
The RCVR MODE hutton lights.
2. Press the ON button to turn on the
TX-SR701/701F-J601/601E (take it out
of the standby state).
To return the TX-SRT01/701E/601/601E to
the standby state, press the STANDBY
button.
ot_ _t,t_v
Memory preservation (Other than USA and Canadian
models and Australian models)
The TX-SR7Oll7OIE/6Oll6OIE does not require memory
preservation batteries. A built-in memory backup system
preserves the contents of memory (e.g., speaker settings and
surround sellings) during power failures and even when the
power is turned off with the POWER swilcb. The backup system
is charged when the POWER switch is turned on.
'Ibe length of time that the memory will be preserved will vary
depending on the ambient climale. On the average, memory
conlents are protecled over a period of a few weeks after the last
time the unit has been turned off. This period may be shorter
when the unit is exposed to a highly humid climate.
Memory preservation (USA and Canadian models and
Australian models)
The TX-SR7Oll7OIE/6Oll6OIE does not require memory
preservation batteries. A built-in memory backup system
preserves the contents of memory (e.g., speaker settings and
surround settings) during power failures and even when the unit
is unplugged. The unit must be plugged in order to charged the
back-up system.
'Ibe length of time that the memory will be preserved will vary
depending on the ambient climale. On the average, memory
conlents are protecled over a period of a few weeks after the last
time the unit has been unplugged. 'Ibis period may be shorter
when the unit is exposed to a highly humid climate.
28
To Next Page
Loading...
