Operating components not reached by the remote
controller signals (IR IN)
In order to use tile remote controller to control tile TX-SR7Ol/
70 IE/601/601E from a remote location, you will need to prepare a
multi-room kit (sold separately) such as one of those given below:
• Onkyo's Multi-Room System kit (IR Remote Controller
Ex/ension System)
• Multiroom A/V distribution and control system such as those
from Niles °') and Xantech Q')
Make the connections as shown below. Do not plug in any
equipment to the power outlet until all the connections are complete.
From
connecting
block
Mini plug cable
If the remote controller signal does not reach the
TX-SR701/701E/601/601 E remote sensor
If the TX-SRT01/701 E/601/601E is located inside a cabinet or other
enclosure where the infrared rays from the remole controller cannot
enter, then operation with the remole controller will not be possible.
In such a case, it will be necessary to install a remole sensor at a
location outside of the cabinet where the infrared rays from the
controller can reach.
With this connection, select "Main" at "HaMware Config" -_ "IR
IN Position" (see page 55).
TX-SR701/701 E/601/601 E
• IR Receiver
[_ CoLonnectlng _
_l _ block _--
IN _:
TX-SR701/
601E Remote Controller
;;e
In the
: Signal flow
'Ihe IR IN input allows you to control the TX-SRT01/701E/601/
601E h'om the remole zone (Zone 2) with the remote controller
even though the remole zone may be on the other side of the
building from the main zone. The diagram below shows how to
make the proper connections for the remote zone.
With this connection, select "Z_me 2" at "Hardware Config" -_ "IR
IN Position" (see page 55).
IR IN
601/_01E
Connectin_
block
Main room
I
IR Receiver
%2
Remote Controller
Zone 2 room
: Signal flow
22
To Next Page
Loading...
