Enjoying music inthe remote zone
ZONE 2 indicator
i OFF _ _<_
E 1
I &-
ZONE2 Input source buttons
_ _ _ INPUT SELECTOR
buttons
_ ZONE 2
Using the buttons
1. Press the ZONE 2 button.
2. Select an input source.
ADer pressing the ZONE 2 buttom you nlust press an input
source button within 5 seconds. The ZONE 2 indicator lights.
Ex.: When tile CD button is pressed.
,._ ....... .'-.-a--' 7 =: =-.r,..
--'jF':.:.'_,-- Z::P--- = --.L..=
To select the same source for the remote zone that is selected
for the main zone, press the ZONE 2 button again until
"Zone2SeI:SOURCE" appears in the display.
Lz,..::ne25e i : .SOURCE
• When "Zone2Sel:Off" is displayed, the output to the remote
zone is turned off.
• When you are not using the remote zone (Zone 2), press the
OFF button to turn off the ZONE 2 indicator.
Notes:
• Ifa sleep time is set with the SLEEP button, the output to the
remote zone will also turn off when the sleep time elapses.
• If the source for the main zone is selemed as the source for the
remote zone and the source for the main zone is changed, then
the source for the remote zone will change as well.
• The ZONE 2 terminal is an analog output. Digital signals are
not output. If no sound is heard from the selected input source,
check if the component is connected to the analog inputs.
• If the REC OUT button is pressed in the main room while
someone is using the system in the remote zone, the Zone 2
function will be deactivated and the source will turn off in the
remote zone.
• If you select FM (or AM) with the TUNER input source button
when the source for the remote zone (Zone 2) is set to AM (or
FM), the output for the remote zone also changes to FM (or
AM).
• When you are using the remote zone (Zone 2), r41 system
operation will not work.
• In the remote zone, you can only play the source in the 2-
channel mode. You cannot play the source in the remote zone in
the surround mode.
I Using the remote controller
With the TX-SR701/701 EJ601/601E in the standby state,
turn on the output to the remote zone (Zone 2):
After pressing the ZONE 2 button, press the ON button within 5
seconds. The ZONE 2 indicator lights.
SEARCH O/_ _T_y
'lb turn off output to the remote zone (Zone 2), press the ZONE 2
button and then the STANDBY button within 5 seconds.
Select an input source:
After pressing the ZONE 2 button, press an input source button
within 5 seconds.
If tuner is selemed with the 'IUN button, you can use the CH button
to select a preset radio station.
8_H
Note:
After you press the ZONE 2 bullon on the remote contxoflex, the
ZONE 2 indica/or on the TX-SR701/7OIE/601/6OIE flashes for five
seconds. During this time, you will not be able to perform
operations in the main zone using the remote controller.
Adjusting the volume for the remote zone
When the remole zone (Zone 2) speakers are connected to the
ZONE 2 SPEAKERS lerminals, or to an amplifier connecled to the
ZONE 2 PRE OUT terminals, adjust the volume as shown below.
Press the LEVEL • / • buttons on the front v _ A
panel.
Adjusting the volume (using the remote controller):
After pressing the ZONE 2 button, the ZONE 2 indicator on the
TX-SR701/7OIE/601/6OIE will flash for 5 seconds. During this
time press the LEVEL • / • button.
8EARClt
6O
To Next Page
Loading...
