Configuring the speakers
Setting the speaker distance from your normal
listening position
Each speaker can be set between I and 30 feet (0.3 and 9 meters) in
1-foot (0.3 meier) increments. Select the setting closest to the actual
distance fiom the speaker to your normal listening position.
Note:
Speakers that you selecled "No" or "None" for in the "Speaker
Conlig" menu will be disabled.
TX-SR701/701E
No_s:
• For the fi-ont L/R, center and subwoofer speakers, the speaker
distance values you can set will be between the current
maximum value(s) among all speakers and the values I0 feet (3
meters) lower than the current maximum value(s). For example,
if the current maximum value is 30 feet (9 meters), the speaker
distance values you can set will be between 20 feet (6 meters)
and 30 feet (9 reelers).
• For the surround and surround back speakers, the speaker
distance values you can set will be between the current
maximum value(s) among all speakers and the values 20 feet (6
meters) lower than the current maximum value(s).
• Whenever you set the speaker distance value for any one of the
speakers, if you enler any values higher than the current
maximum value, the value you enter will be the new maximum
value and any other speaker distance values you ah'eady set will
automatically be ad.jusled to the values so that they keep the
same value difference to the new maximum value as the one to
the last maximum value.
1. Use the • and • cursor buttons to
select "3. Speaker Distance" on the
main menu and then press the
ENTER button,
The "Speaker Distance" menu appears.
* Merlkl *****************
1.Hardware Config
2.Speaker Confi@
k3.Speaker Distance J
4.Level Calibration
5.Input Setup
6.Preference
_I_IIEHTERIQuit:ISETUP I
[3° 5P O is_rre
3.Speaker Distance
***********************
[a.Unit :feet
b.Left :12ft
c.Center :12ft_
d. Right :12ft_
e.Surr Right : 7ft_
f.Surround Back : 7ft_
g.Surr Left : 7ft_
h. Subwoofer : 7ft_
[]_ Quit:ISETUP I
[ Ut_ i 9 : _ee 9
2. Use the • and • cursor buttons to select "Unit" and
then use the < and • cursor buttons to select the
desired unit of measure.
feet: Select if you will enter the distances in feet.
meters: Select if you will enler the distances in meters.
3. Use the • and • cursor buttons to select"Left" and
then use the < and • cursor buttons to set the
distance from the front left speaker to your normal
listening position.
4. Use the • and • cursor buttons to select "Center" and
then use the • and • cursor buttons to set the distance
from the center speaker to your normal listening position.
5. Use the • and • cursor buttons to select"Right" and
then use the • and • cursor buttons to set the
distance from the front right speaker to your normal
listening position.
6. Use the • and • cursor buttons to select"Surr Right"
and then use the • and • cursor buttons to set the
distance from the surround right speaker to your
normal listening position.
7.
Do the following when you use two surround back
speakers. If you use one surround back speaker, go to
step 8.
Use the • and • cursor buttons to select "Surround
Back R" and then use the • and • cursor buttons to
set the distance from the surround back right speaker
to your normal listening position.
8,
When you use one surround back speaker:
Use the • and • cursor buttons to select "Surround
Back" and then use the • and • cursor buttons to set
the distance from the surround back speaker to your
normal listening position.
When you use two surround back speakers:
Use the • and • cursor buttons to select "Surround
Back L"and then use the • and • cursor buttons to
set the distance from the surround back left speaker
to your normal listening position,
9. Use the • and • cursor buttons to select "Surf Left"
and then use the • and • cursor buttons to set the
distance from the surround left speaker to your
normal listening position.
10. Use the • and • cursor buttons to select "Subwoofer"
and then use the • and • cursor buttons to set the
distance from the subwoofer speaker to your normal
listening position,
Press the RETURN button to return to the main menu.
Press the SETUP bullon on the front panel or SETUP button on the
remote controller button to exit the Setup menu.
33