Playing Your AV Components
This chapter explains how you can play yourAV components
through the TX-SR501/TX-SR501E.
Seepages 10 19 for informalion on connecting your AV
components to the TX-SR501/TX-SR501 E.
r=q
...... Eo
To adjust the volume, use the MAS-
TERVOLUME control, or the
remote controller's VOLUME [A]
[T] buttons.
The volume can typically be set to MIN, 1
though 79, orMAX.
SPEAKER AUDIO
A&B SELECTOR
SP A--
SPB-- _@
CH SEL--
AUDIOSEL --
Input selec- --
tot buttons
Input selector MASTER
buttons VOLUME
-- Press [RCVR/
TAPE] to select
RCVR mode.
--LEVEL V/&
-- VOLUME V/&
/
Using Digital Inputs
The digital input assigned to the input source (see page 24)
has priority over that input source's analog input. To use the
analog input, set the input source's format to Analog (see the
following section).
The format of the digital input signal appears on the display,
as shown: DOLBY DIGITAL, DTS, DTS-ES, or PCM (ste-
reo).
DOLBY DIGITAL DTS PCM
DTS-ES
]se the following input selector
buttons to select the AV compo-
nent: [DVD], [VIDEO 1], [VIDEO 2],
], [TAPE], or [CD].
The name of the selected source appears
on the display, as shown.
B speakers indicators Volume
; t .f.t.. t... _. r_
............ -'-'.-..-.-.=
"_." ./, _.."/... :...: _..: ,... ,....
Selected input source
If you're using a MiniDisc recorder, you
can set the display to show "MD" instead
of "TAPE." See page 25.
[A] and [B] but-
tons, or the remote controller's
[SP A] and [SP B] buttons to select
the speaker set that you want to
use.
Press the remote controller's [RCVR/
TAPE] button to select RCVR mode
before using the remote controller,
The A and B speaker indicators show
whether each speaker set is on or oft:
Start playback on the selected AV
component.
Other Functions:
See page 32 for functions that you can use while listening to
your AV components.
Listening Modes:
See page 34 for information on the listening modes that you
can use while listening to your AV components,
Remote Controller:
See pages 40, 41 for information on using the TX-SR501/
TX-SR501 E's remote controller to control your other AV
components,
With this function you can choose which signal format (ana-
log or digital) you want to use forAV components that are
connected to a digital input and analog input. When an input
source is assigned to an OPTICAL or COAXIAL digital
input (page 24), the digital input has priority over the corre-
sponding analog input. However, with this function you can
override that and force the TX-SR501/TX-SR501E to use the
analog input, in addition, you can set the DVD input source
to use the mulli-channel inputs.
Press the input selector button for
the source that you want to set:
[DVD], [VIDEO 1], [VIDEO 2],
[VIDEO 3], [TAPE], or [CD].
The name of the selected source appears
on the display,
Press the [AUDIO SELECTOR] but-
ton.
The current format appears on the display
for about three seconds.
28
To Next Page
Loading...
