Using the Tuner
This chapter explains how to use the built-in tuner,
YOUcan store your _axorite radio stations as presets for con-
xenient selection.
@@
MASTERVOLUME
_1 PRESET/ADJUST I_
<1 TUNING I_
MEMORY TUNER
FM MODE
='=_' PRESET<I / I_
wW= w_m w_l
_ TUNER
Use the [TUNER] input selector
button to select either AM or FM.
In this example, the FM hand has been
selected.
-::_.:" _ ;,j':__'"-"_::, .....
Band Frequency
To adjust the volume, use the MAS-
TER VOLUME control.
The volume can typically be set to MIN, 1
though 79, or MAX.
Press and hold theTUNlNG [<] or
[I,_] button for more than half a sec-
ond and then release it.
If you selected the FM band:
The AUTO indicator appears on the display and the
TX-SR501/TX-SR501E searches for the next station auto-
matically. Searching stops when a station is found, and the
TUNED and FM STEREO indicators appear, as shown,
TUNED AUTO
,--=M-,?-_--,.
FM STEREO
If you're using the Worldwide model (i.e., your TX-SR501/
TX-SR501E has a VOLTAGE SELECTOR on the rear
panel), you need to set the AM tuning interval for compati-
bility with AM broadcasts in your particular country. The ini-
tial setting is 9 kHz.
North America: 10 kHz
Other countries: 9 kHz
To set the AM tuning interval, while
holding down the [TUNER] button,
press the [MEMORY] button.
Note:
All presets are deleted when you change this setting.
The North American model searches the FM band in
0.1 MHz intervals. For other models it's 0.05 MHz.
If you selected the AM band:
The frequency stops changing when you release the TUN-
ING button. The TX-SR501/TX-SR501E doesn't automati-
cally search forAM stations. You must use the TUNING [<]
[_-] buttons, Press repeatedly to change the frequency one
interval at a time, or press and hold to quickly change the
frequency. When you're tuned into a station, the TUNED
indicator appears.
The North American model steps through the AM hand in
10 kHz intervals, For other models it's 9 kHz,
To fine-tune the frequency, use the
TUNING [<] [P-] buttons.
If you've selected the FlVlband, he careful
that you don't press either button for more
than halfa second, otherwise the
TX-SR501/TX-SR501E will start search-
ing for the next station.
3O
To Next Page
Loading...
