Using the Remote Controller RC-518M withYour Other AV Components--Continued
Using the RC-518M
If you need to enter the manufacturer's code for your AV
component into the remote controller, see page 41.
Use the remote controller's Power [©/I] but-
Remember, if your AV component is connected to
the TX-SR501 via ['_ I, point the remote controller
at the TX-SRS01. If not, point the remote control-
ler at the AV component.
(A cassette recorder can't be turned on or off from
the remote controller. However, pressing the remote
controller's Play [_] button will turn it on and start
playback.)
Use the buttons as explained below.
in the following illustrations, buttons that control the
TX-SR501 regardless of which mode is selected are
shade&
DVD mode *I CD mode *I Tape mode .2
u u
u < •
u
--3. o/I
--2. CD/DVD
--4. DVD
control
buttons
...........1. DVD input
selector
m
--3. o/I _
--2. CD/DVD _?
°4. CD -_
control _= _ ._
buttons I_?
.... [
1. CD input
selector
©/I
II
DISC
1-9, +10, O
TOP MENU
MENU
RETURN
SETUP
&IVI<III_"
ENT
You nmst enter the appropriate manuthc-
turer's code fbr your DVD player (see
page 41).
Power on/off
Start playback
Stop playback
Fast forward
Fast reverse
Pause playback
Go to next chapter or track
Go to beginning of current chapter or track
Select a disc (DVD/CD changers only)
Enter numbers
Display the disc's main menu
Display the last sub-menu
Return to previous menu
Display setup menu
Select menu items
Go to selected menu item
CD mode can be used only with an Onkyo
CD player, and you must enter the appropri-
v
ate Onkyo CD player code (see page 41 ).
2. RCVR_APE
--3. Tape control
buttons
--1. Tapeinput
selector
Play side A (front-facing side)
Stop playback, recording, fast forward, or
Stop playback, fast forward, or fast reverse rewind
Rewind
Play side B (rear-facing side)
*2 Since this is RCVR/TAPE mode,
you can control the cassette
recorder and fully control the
TX-SR501 at the same time.
.1 Since you can only enter a CD code
or DVD code for the [CD/DVD]
button, you can use CD mode or
DVD mode, but not both.
42
To Next Page
Loading...
