Onkyo TX-SV525R - Using the Tuner: Radio Operation; Manual and Direct Radio Tuning; Stereo FM Listening and Mono Conversion

20
Using the tuner
Please make sure that the TAPE-2 MONITOR indicator is off and audio muting is off.
Z > 2
FM MUTE/MODE 1,1
When the frequency is not known—Manual tuning
1. Press the FM or AM button.
2. Use the < DOWN TUNING UP P buttons to change the
frequency.
UPL the frequency increases.
DOWN ....the frequency decreases.
e The frequency is changed in 50 kHz steps in FM and 10 kHz
+ vowN _TUNNG ROP CP fog (or 9kHz) in AM when the tuning selector button is pressed in
single steps.
e If this button is held continuously for more than 0.5 seconds,
the frequencies are scanned automatically. (FM auto tuning
mode)
When a broadcast is received, scanning stops.
.
.
.
= .
a. ovens
When the frequency is known—Direct tuning
. Press the FM or AM button.
2. Press the DIRECT TUNING button.
The ‘*-- --” will flash 16 seconds in the frequency display.
?, Enter the frequency with the number buttons while the cur-
sor are flashing.
DIRECT TUNING Example: 88.10 MHz 8 > 83> 150/10
seats acess @ When receiving AM broadcasts with a 9 kHz step (this depend-
ing on your region), you can enter the frequency directly.
e@ With 10 kHz steps, entering a number for the 10 kHz digit will
set the | kHz digit automatically to 0.
e If you enter a frequency that does not have a station, this unit
will automatically tune to the next station immediately below
that station.
e Ifyou enter a frequency that is out of range, this unit will return
to the previous frequency. If this happens, repeat the procedure.
FM
MUTE.MODE
If
you
tune
in
a
stereo
FM
station,
the
STEREO
indicator
will
be
O
illuminated
if
the
signal
is
sufficiently
strong.
If
the
signal
is
weak,
it
may
be
impossible
to
tune
in
to
your
desired
station.
In
this
case,
tune
in
as
follows.
Press
the
FM
MUTE/MODE
button
and
FM
MUTE
OFF
lights.
At
this
time,
the
station
will
be
in
mono
and
interstation
noise
will
be
heard.
Select
the
station
you
want
listen
to.