Onset Computer Corporation
3
Task 2: Supply Power to the Receiver
Use the supplied power adapter to connect the receiver to a
wall outlet.
A. Insert the connector into the Pwr jack on the receiver
and plug the adapter into a wall outlet.
B. Insert 3 AAA batteries into the receiver for backup
power.
Installing Batteries
IMPORTANT: Do not install batteries into the data nodes at
this time; only install batteries in the receiver.
1. Twist cover counterclockwise to remove.
2. Insert 3 AAA batteries.
3. Replace the cover, aligning the threaded hole on the
cover (a) just above the hole on the case (b).
4. Twist cover clockwise to secure. The mounting holes
should be at the top and bottom of the case and the
threaded screw hole should be aligned with the hole in
the case.
Next Task: Supply Power to the Data Node
Onset Computer Corporation
4
Task 3: Supply Power to the Data Node
Onset strongly recommends that you deploy data nodes where
they can be plugged into a wall outlet, which allows them to
route data from other data nodes. This optimizes your network
reliability.
What to look for: To verify that you have powered the data
node correctly, watch the LEDs when you connect power. Both
the RED and GREEN LEDs flash for 5 seconds, then the RED
LED blinks for 5 seconds, then both LEDs blink once, and then
both LEDs go OFF. This confirms that the data node is powered
using a wall outlet and can route data.
Use the supplied power cord to connect the data node to a wall
outlet.
A. Insert the power cord connector into the Pwr jack on
the data node.
B. Insert the power plug into a wall outlet.
C. Insert 3 AAA batteries for backup power.
Next Task: Connect the Receiver to your Computer
To Next Page
Loading...
Need help?
General
