13
Retrieve the top and side panels from the packing foam you set
aside after removing the crate top.
12
Fit the window panels to the Flex by following the labeling
information on the front protective lm. Then remove the
protective lm.
13
Using the beveled window screws and the 2.5 mm screwdriver
from the User Kit, attach the window panels to the Flex. Make
sure the beveled (V-shaped) holes in the window panels are
facing out (towards you). This allows the screws to t ush with
the surface of the window.
14
Warning: Incorrectly orienting the panels can lead to
damage. Excessive screw torque can crack the panels.
Hand tighten the screws until the window panels are
reasonably secure. This is not a trial of strength.
To Next Page
Loading...