What to do if OPHIR StarBright fails when sensor heats up?
If your OPHIR Measuring Instruments device responds while the sensor is cold but suddenly fails as it heats up, have the sensor disc replaced.
General| Brand | OPHIR |
|---|---|
| Model | StarBright |
| Category | Measuring Instruments |
| Language | English |
Guides users on connecting sensors, powering on, and basic instrument settings.
Explains how to use StarBright with Thermopile sensors for power and energy measurements.
Details using StarBright with Photodiode sensors for power measurements and setting parameters.
Covers using StarBright with energy sensors, including zeroing and parameter setup.
Details connecting and operating StarBright with Thermopile absorber sensors.
Explains the procedure for measuring laser power using Thermopile sensors.
Covers measuring single shot energy with Thermopile sensors.
Guides on configuring parameters for BeamTrack sensors in Track mode.
Explains how to track beam position and size using BeamTrack sensors.
Covers connecting and operating StarBright with Photodiode sensors.
Explains how to measure laser power using Photodiode sensors.
Explains the operational principles of Pyroelectric sensors.
Explains the operational principles of Photodiode energy sensors.
Guides on using StarBright with energy sensors, including zeroing.
Outlines general steps for updating sensor calibration factors for better accuracy.
Covers absorber types and calibration methods for Thermopile sensors.
Explains factory calibration and accuracy for Photodiode sensors.
Details absorber types and calibration for Pyroelectric sensors.
To Next Page
