Optex iVision+ IVP-HU

To Next Page

Avoid using the Handheld Monitor Unit in the following areas

- Close to a fire, thermal appliance or other source of extreme heat/cold.

- Within 10ft (3m) of a television, microwave oven, personal computer, wireless

LAN equipment, wireless audio/visual equipment - the radio frequency waves

emitted by these devices can affect operation.

- In direct sunlight.

- Where extreme fluctuations in temperature can occur - if moving the unit from

a warm to cold environment, or vice versa, please allow 30 minutes before use.

IVP-HU features

2.4 inch TFT LCD Monitor

Wall-mountable Cradle

Max 4 Units in a System

micro-USB port to PC connection

Manual/Auto Talk Switching

IVP-HU

(Handheld Monitor Unit)

Installation Instructions

ATTENTION:

Thank you for purchasing the iVISION+ wireless video intercom.

Before installation and usage, please read this instruction manual thoroughly

and keep this safe for future reference.

Wireless Video Intercom

IMPORTANT NOTICE

Privacy & portrait/image rights

- Please respect the privacy and image rights of others when using this

equipment. By using this equipment the user assumes total responsibility in

upholding these rights.

- Images stored must not be used for any purpose other than that for which the

equipment is designed.

- Images should be deleted once no longer required.

Operations under harsh environments such as out of warranted temperature,

rapid temperature change, high humidity, constant moisturization may cause the

unit to malfunction.

Electronic device such as TVs, Radios, PCs, Microwave ovens or any other device

with an electric motor may cause the unit to malfunction.

Impact or shocks can cause severe damage to the unit. Please handle the unit

with care and operate without exerting strong forces.

Transmission range of communication between units may decrease under

the following conditions.

- Any unit is installed on a metal surface.

- Presence of reinforced concrete, steel doors or other metal construction

materials between units.

- Places near strong radio sources such as broadcast stations or substations.

PARTS IDENTIFICATION

CHOOSING LOCATION

INSTALLATION

POWERING THE UNIT

The performance of the iVISION+ system is dependent on the radio frequency

environment and distances between devices. Following materials may decrease

the maximum transmission distance and may cause the Handheld Monitor Unit

inability to respond to incoming signals.

• Metal barricades such as ,metal doors and shutters.

• Walls with aluminium foil insulation.

• Concrete or galvanized metal walls.

The effective communication range is around 300ft (100m) in an open air condition

(line of sight). This range will be significantly reduced by the number and thickness

of walls through which the signal is required to pass. Please keep to a minimum

number of walls wherever possible.

Handheld Monitor Units use 2.4GHz radio frequency. Any electrical appliance may

become a potential cause for malfunction. Please avoid using the Handheld Monitor

Unit near microwave oven or any electrical devices with similar radio frequency.

CAUTION

Please use the includedbattery pack and a power adaptor only.

Do not disassemble or attempt to use alternative battery packs.

Handheld Monitor Unit must be set on Charging Cradle to retain its power while

iVISION+ system is not in operation. The Charging Cradle can either be free-standing

on a horizontal surface or be mounted on a wall as described below.

Charging Cradle

Mounting Screw

Handheld Monitor Unit

AC Adaptor

Battery Pack

1. Connect Battery pack

to the main unit.

LCD display

LEFT function key

“OPEN DOOR”

“SNAP”

“BROWSE”

Scroll buttons

( UP/ DOWN)

Microphone

“BRIGHTNESS”

“PLAY”

“OFF”

“ANSWER”

RIGHT function key

2. Connect AC adapter

to Charging Cradle

3. Press and hold “OFF”

button to power on.

Set the unit onto

the cradle for charging.

Remove and keep the battery seperately if the device is not used

for more than a month. It may require several charge-discharge process

before a battery regains its full capacity after a long storage period.

Battery Pack Compartment

Speaker

USB connection port

Battery Cover

Pairing button

Need help?

Do you have a question about the Optex iVision+ IVP-HU and is the answer not in the manual?

Summary

Important Notice and Precautions

Operational and Environmental Considerations

Covers operating conditions, electronic interference, handling, and factors affecting transmission range.

Privacy and Image Rights

Guidelines for respecting privacy and responsible use of stored images.

Parts Identification and Features

Handheld Monitor Unit Components

Identifies key components of the Handheld Monitor Unit, including display, keys, speaker, and microphone.

IVP-HU Key Features

Highlights features like 2.4-inch LCD, wall-mount cradle, multi-unit support, and PC connectivity.

Choosing Installation Location

Factors Affecting Transmission Range

Details materials like metal, concrete, and radio sources that reduce range and signal strength.

Optimal Communication Range

Explains the expected range in open air and how walls reduce it.

Installation and Powering

Installation Guidance

Instructions for mounting the charging cradle and setting up the handheld unit.

Powering the Unit

Steps for connecting the battery pack, AC adapter, and powering on the device.

Pairing with Other iVISION+ Devices

Creating a Home ID

Procedure for establishing a unique network identification for the iVISION+ system.

Enrolling Devices to Home ID

Instructions for pairing additional units like Door Cameras, Handheld Monitors, and Gateway Chimes.

Operation Checks and Specifications

Confirming Device Network

Steps to verify the number of iVISION+ devices registered in the network.

Checking Unit Operations

Procedures to confirm RF reception, signal transmission, and audio communication.

Device Specifications

Details on operating temperature, humidity, frequency, power, and dimensions.

Warranty Information

Warranty Period and Terms

Information on the 18-month warranty, applicable conditions, and exclusions.