3
OPERATING INSTRUCTIONS
Power On
• Turn on the power by ipping the switch located on the underside of the
scale to the left. Once on, the scale with auto-check and count down
from 0-9 sequentially. It will then show the voltage
for 2 seconds before entering the weighing mode
Zeroing
• If the screen reads any number other than 0 before weighing, press the
ZERO key to set to 0
Unit Selection
• To switch between measuring units (kg, g, lb, oz) press the [UNIT/
PRINT] key
Tare Function
• Put a container you wish to use on the pan, then press the [TARE] key
and the display will show the tare symbol and reset back to 0
• Add your sample to the container to weigh without the weight of the
container
• To exit Tare mode simply press either [TARE] or [ZERO] key
Note: If you remove your container the scale will show the minus weight of
the container
To Next Page
Loading...
