OPTIMUM
MASCHINEN - GERMANY
Maintenance
© 2010
GB
Page 419 / 03 / 2010 Version 3.1.4 BF 20 Vario ; BF 20 L Vario Drilling-Milling machine
As required
Taper gibs
Readjust
X- and Y- axis
Fig.5-2: Cross table
Turn the adjusting screw of the respective taper gib in the
clockwise direction. The taper gib is continued to push in
and reduced by it the gap in the guideway.
Control your setting. The respective guideway must be
still easily mobile from the adjustment, result in however a
stable guidance.
As required
Taper gib
Readjust
Z-axis
Fig.5-3: Mill head
Proceed as described under "Readjust X- and Y-axis".
Interval Where? What? How?
To Next Page
