USING YOUR H3000 2nd Gen ADVANCED WHOLE MOUTH SLOW JUICER
1 4
2
5
6
3
Attach the feeding tube to the base:
a. Align the arrows on both the feeding chute
and the lock catch;
b. Rotate the feeding chute anticlockwise
to ‘click’ the feeding chute in the locked
position securely.
Attach the pulp extractor to the feeding chute:
a. Aligning the pulp extractor to the juicing
screw, juice strainer and feeding chute,
attach the pulp extractor;
b. Rotate the pulp extractor anticlockwise
to align the “▲” sign on the feeding chute
to the “ ”sign on the pulp extractor. If not
installed securely, the pulp extractor will fall
Align the juicing screw to the lock catch of the
base and push the juicing screw through the
lock catch.
Tip: Rotate the juicing screw slightly to install. Place the juice cup below the juice tap.
Place the pulp cup under the pulp extractor, as
close to juice cup as possible.
Align the juice strainer to the juicing screw
and push through towards the lock catch of
the base.
A AB B
To Next Page
Loading...
