Optimum VIBE User Manual

OPTIMUM VIBE PROGRAMMABLE THERMOSTAT - USER INSTRUCTIONS
Transmier and receiver display / controls
Receiver
operate the receiver
manually
switch the receiver
on or o
Temporary override using the UP and DOWN arrow icons.
Whilst in program mode (display shows PRG in the top-right) , you can adjust the set temperature by touching
the UP or DOWN arrows. This is a temporary override of the current temperature seng. The display will
change from showing ‘ROOM’ and the current measured temperature, to showing ‘SET’ and the temperature
that you are now seng. Five seconds aer you have changed the temperature to the value you want for the
me-being, the thermostat will ‘me-out’ and once again show ‘ROOM’ and the measured temperature. The
heang will be switched ON or OFF according to the adjustment you have made. The programmed me / tem-
perature seng will be restored with the next program entry in the memory.
Permanent override—manual mode using the SET icon
In the program run mode, touch the SET icon briey to choose between Program mode (PRG) or manual mode
(sun symbol ). In manual mode you can set a dierent temperature from the programme. Manual mode is a
permanent selecon which will only change if you touch the SET icon again. Program mode (PRG) runs the pro-
grammed me & temperature sequence.
Set the me & weekday:
Insert the baeries with correct polarity. The screen will jump to me-seng mode. Or—during normal opera-
on, touch the SET icon for 5 seconds to go into me-seng mode. Using the UP and DOWN arrow icons you can
set the current me—you must also set the weekday. Whether you change a value or not, touch the SET icon to
conrm and move on to the next seng. Go back to run mode by pressing ON/OFF or BACK, or the VIBE will
‘me-out’ to run mode aer about ten seconds.
SET
SET
Touch-sensive buons:
Power
Heang on
OVERRIDE
(short press)
RF LINK
(long press)
ON/OFF
Transmier
switch on or o
PROG to programme
SET to select pre-set temperatures
increase / decrease temperature
back icon to go back
VIBE
ON/OFF
UP
PROGRAM
DOWN
SETTINGS
BACK
PROG
SET
Program mode
Current program number
Manual mode
Weekday indicator
Current me
Heat demand indicator
Temperature
0
C
Set temperature—during programming or when manually changing
Room temperature (default temperature display)

Optimum VIBE Specifications

General

Brand	Optimum
Model	VIBE
Category	Thermostat
Language	English