Optimus IT-100 - Factory Default Settings

R+D Department
IT-100 v1.2 8
DTMF telephone interface
IT-100
PARAMETER 8: Hang-up tone detection time.
Depending on the type of exchange or the quality of the telephone line, the module could mistake a tone
of voice for the hang-up tone. If this occurs, increase this parameter so that a longer detection time is
programmed.
Values of 0 to 9 are admitted, increasing the hang-up tone detection time by 25 ms with each value (0 =
disabled, 1 = 25 ms … 9 = 225 ms).
PARAMETER 9: NOISE GATE
Through this parameter, the noise gate available on this telephone interface can be activated (dial 1) or
deactivated (dial 0).
PARAMETER 10: COMMUNICATION TIME
This determines the maximum communication time. Once this time has elapsed, the module will hang up
automatically.
P10
MAXIMUM COMMUNICATION TIME
0
8 seconds
1
15 seconds
2
30 seconds
3
45 seconds
4
60 seconds
5
75 seconds
6
90 seconds
7
105 seconds
8
120 seconds
9
900 seconds (15 minutes)
5.2. FACTORY DEFAULT SETTINGS
The module is factory configured as follows:
0
0
0
2
0
0
0
4
0
2
PASSWORD
ANSWER ON
2
nd
CALL TONE
-----
-----
-----
Detection of
hang-up
tone
Noise gate
deactivated
MAX. TIME
30 s.
ATTENTION: By assigning a 0 to this parameter, the automatic hang-up function is deactivated; in
this case, if the telephone hangs up and the communication time (parameter 10) has not ended, the
hang-up tone will be heard over the Public Address system until this time has elapsed.
To avoid this, the system includes the function of forcing hang-up by pressing key 1. When 1
is pressed, independently of the values assigned to parameter 8 (hang-up tone detection time) and to
parameter 10 (communication time), the telephone hangs up.