Optoma TX779P-3D - Page 35

English
35
Setup | Signal
Automatic
Enable or disable Automatic to automatically select the appropriate
settings.
4
Enabled - the projector will automatically select the appropriate settings.
4
Disabled - the projector won’t automatically select the appropriate settings.
Frequency
Change the display data frequency to match the frequency of your
computer’s graphics card. If you experience a vertical 󰘱ickering bar, use
this function to make an adjustment.
Phase
Phase synchronizes the signal timing of the display with the graphics
card. If you experience an unstable or 󰘱ickering image, use this function
to correct it.
H. Position
4
Press ◄ to move the image left.
4
Press ► to move the image right.
V. Position
4
Press ◄ to move the image down.
4
Press ► to move the image up.
User Controls