________________________________
25
Insertion of Batteries
Remove the battery lid at the handle of the unit.
Remove the battery holder and insert the
batteries. Observe the correct polarity.
Charging of the Batteries
In order to charge the batteries please connect
the charger cable to the USB interface.
Scope adjustment
In order to adjust the scope remove the
protection caps. Using a screw driver you
can adjust the middle of the cross hair.
Adjust the cross hair to the middle of the
laser dots.
Basic Operation
TEMPERATURE MEASUREMENT
Please aim with the unit at the target and press
the TRIGGER.
HOLD function: After release of the TRIGGER all
display values will be shown for 7 seconds.
Shut down: If you do not press any button
during the HOLD mode the unit shuts down
automatically after 7 seconds.
DISPLAY BACKLIGHT
Please press the DOWN button while the
TRIGGER is pressed to switch the display
backlight on or off.
LASER
Please press the UP button while the TRIGGER is
pressed to activate/ deactivate. The current
status will be shown in the display.
To Next Page
Loading...
Need help?
General
