________________________________
27
Shiny or metallic surfaces may result in
inaccurate reading due to reflexions. To prevent
this, cover the measuring surface with either flat
black paint or with plastic labels.
Setting the emissivity: Press the MODE button
(during HOLD mode) – with UP and DOWN you
can adjust the value. The shown temperature
value corresponds to the emissivity adjustment.
This allows a correction of even after the
measurement has been done.
MAX/ MIN
With this function you can select if the maximum
or minimum value will be shown permanently in
the upper part of the display.
To switch between both please press the MODE
button, either during the HOLD mode or during
a measurement (while the TRIGGER is pressed).
The made setting will be saved, also after the
unit switched off.
If you press the MODE button after you made a
measurement (during the HOLD mode) the
determined maximum and minimum value taken
during that measurement will be displayed.
ALARM FUNCTIONS
To activate/ deactivate please press the UP or
DOWN button if the H or L is shown in the
display. The alarm function is activated as soon
as the display shows the sign .
After pressing MODE again the alarm values can
be adjusted using the UP and DOWN button.
If the temperature exceeds the selected High
value an acoustic signal will appear and the
display color will change to RED.
If the temperature falls below the selected Low
value an acoustic signal will appear and the
display color will change to BLUE.
°C/ °F SETTING
To setup the temperature unit to °F please
press the DOWN button (keep pressed) and then
the TRIGGER.
To Next Page
Loading...
Need help?
General
