15
OPEN THE BED LID
• Open the bed lid through 180°. Gas struts are fitted to support the weight of the lid at this stage.
• Secure the lid to the stone guard frame with the latch and secure with the retaining pin.
• At this stage walk around the OPUS® and inspect the tent to ensure that the canvas is properly located within the alu-
minum channels and that no part of the tent is caught or snagged.
• Fit each corner of the canvas over the corner of each bed tray. The seam on the canvas should line up with each corner
of the bed lid.
INFLATE YOUR TENT
• Ensure all five of your quick release valves on the driver’s side are closed.
• Open the control panel door and if not already connected, insert and turn the red turn-key to power-on your vehicle.
• Press the Air Inflation button on your control panel to activate your compressor. - Wait for the tent to inflate to its full
height before entering the camper. The compressor may still be running after the tent has extended to its full height;
this is normal and is simply the compressor increasing the PSI to the required setting to make the Air Poles appropriately
inflated. Once the correct air pressure is achieved the compressor will shut off automatically. There is no need to press
the button again. IMPORTANT: Do not set up the interior of the camper until the tent has inflated to its full height. This
can be identified by the visual ‘popping-up’ movement of the camper and by the straightening of the air poles.
STEP 3
STEP 4
AIR
To Next Page
Loading...
