Opus OP2 - OP2 Set-Up Procedure (Continued); Set-Up Interior; Set-Up Tips

17
• Ensure all five of your quick release valves are closed prior to inflating your camper.
• Ensure the center AIR beam is secured in place in the bed corner before inflating.
• Pull back the tension straps and tie them down to ensure the tent is sitting properly.
• While inflating, check that the OPUS® is stable and level prior to opening the two lids.
• IMPORTANT: Do not place or load anything on top of the tent whilst it is inflating.
• IMPORTANT: Ensure children or frail adults maintain a distance of 5ft from the air poles whilst it is inflating.
• Should you need to switch off the compressor for any reason whilst the tent is inflating, this should be done using the
main power switch.
• Please note that the Air OPUS switch is not a 2-way on/off switch (meaning that pressing this twice will not turn the
compressor off).
SET-UP TIPS:
SETUP INTERIOR
• Turn the lights on via the control panel.
• The foot-well lights are controlled by the dimmable light switch on inside on the right of the door. Connect the interior
ceiling lights into the 12v mini outlet.
• Set up your sofa. start with the center-back cushion, followed by the corner back cushions, then the side-back cush-
ions.
• Fold out the legs of the table. Adjust the height of the table by pulling out the pins and extending the legs.
STEP 7
See the shower section for information
to set-up your hot water shower.
LIGHTS