18
PACK DOWN THE INTERIOR
• After stowing your personal items, close all both layers of all windows, making sure no water, dirt or debris is trapped
between the layers.
• Ensure mattresses are secure using the straps provided
• Remove LED lights from the 12v mini sockets
• Tear down the sofa and fold away the table; stow the back cushions and table as shown in the below picture to
optimize foot well storage space for other items and to ensure your table and cushions are stowed to prevent damage.
1. Seat cushions can remain in place
2. Corner cushions stowed on the bottom, backs to the floor
3. Back cushions stowed in footwell
DEFLATE THE TENT
• Ensure that all users are outside of the tent and zip the front door closed.
• Open all 5 quick release valves, located externally on the offside of the
camper on each of the vertical air poles. Make sure you release the valves
using the middle ring as shown in the image. Allow the tent to deflate.
FOLD AWAY THE BED LID
• Lift the canvas off of the bed-end corners and fold the tent inside the seals of the trailer. Try to fold the tent into the
main body of camper as much as possible; this will help to make closing the camper easier.
• Retract the steps and fold up and latch the door.
• Disconnect the bed-end supports and latches and fold over first the rear lid, then the front lid. Do not try to latch down
the bed lid yet
• Walk around the camper to make sure that all of the tent is folded away within the seals.
• Push the bed lid down to allow air to escape. Twist open the triangle bolt latches to the maximum and push down on
the bed lid so that the latches are over the hook. Do not try to close the latches until you have done this for each latch;
the easiest and most efficient way to close the bed lids is to do it gradually.
• Push down on the bed lid enough to allow you to close the latches closest to the hinges first.
•
IMPORTANT! Do not use the latches as a lever to close the bed lid as this may cause damage to the camper and is not covered under warranty. Once you have closed
the latches at the maximum extension of the triangle bolts, move around the trailer and tighten each latch. Each latch should be checked for a tight fit several times
as tightening one can loosen others. Make sure that no tent is outside of the seal.
CUSHION PACK DOWN
OP2 PACK-DOWN
STEP 1
STEP 2
STEP 3
To Next Page
Loading...
