ORANGE DARK TERROR - Operating Modes and EQ Controls

DARK TERROR
ENGLISH
12
12
USING THE DARK TERROR
Selecting Output
The output switch (found next to the power switch on front of amplifier) runs the valves at a low
plate voltage (reducing output power) in the HALF position and at a higher plate voltage (increasing
output power) in the FULL position. The middle position is the standby position. This switch should
be in the standby position for around two minutes after first powering up the amplifier!
OUTPUT POWER COMBINATIONS
Output switch HALF
2 OUTPUT VALVES
7 watts
Output switch FULL
2 OUTPUT VALVES
15 watts
Using EQ
GAIN CONTROL. The gain control adjusts the gain.
High levels of gain will heavily overdrive the pre-amp and may sometimes be
uncontrollable, especially when used at high volume levels!
SHAPE CONTROL. The shape control adjusts between all midrange (zero) to all bass and treble
and no midrange (maximum).
VOLUME CONTROL. The volume control adjusts the output volume. High levels of volume will
heavily overdrive the output stage!