Orbic SPEED 2 - Setting up Your WPS

11
Setting up your WPS
If your terminal support WPS, you do not have
to input the password manually once your WPS
has been set up.
To use WPS please follow these steps:
1. Through WebUI: Enable WPS through
Wi-Fi > WPS.
2. Click Connect button to activate the
WPS function.
3. Enable the WPS function on the device
being connected to the Orbic Speed 2
5G.
-OR-
1. Through WPS button: Double-click the
Power/WPS button to activate the WPS
function.
2. When WPS is activated, the Wi-Fi
indicator will be green blinking.
3. Enable the WPS function on the device
being connected to the Orbic Speed 2
5G.
Note: If there’s no connection, the Wi-Fi
indicator stops blinking after two minutes.