9
1. Battery Replacement
a) Use a coin to rotate the battery cover counter-clockwise by 90 degree, following the
arrow direction shown in PICTURE 1 below. Take the old battery off.
b) Replace with new battery and put the battery cover back. Rotate the battery cover
clockwise by 90 degree, shown in PICTURE 2.
NOTE: Make sure the positive and negative poles are in correct position,
shown in PICTURE 3.
c) Use CR2032 battery.
NOTE: Battery should be re-newed every 3 months, no matter item is
frequently in use or not.
d) Make sure the transmitter sensor is turned “ON” while using, and turned “OFF” after
exercise is done.
2. Once the replacement is completed, “STOP” on meter will be disappeared.
3. Meter placement
a) Distance between meter and transmitter sensor must be within ONE METER, shown
in PICTURE 5. Otherwise, wireless function cannot work successfully.
NOTE:
1) Conductor or conductor material must be removed between meter and
transmitter sensor.
2) Meter cannot be placed on steel-made table or platform, including iron,
aluminum, and stainless steel, otherwise the transmitter signal will be
blocked.
3) Meter will be placed far away from smart phone, laptop, tablet, or router.
Suggested distance is over 30 cm.
Transmitter Function
PICTURE1
PICTURE2
PICTURE3
RF-SENSOR
Rmax=100CM
PICTURE5
To Next Page
Loading...
Need help?
General
