ASSEMBLY INSTRUCTION
STEP 1
1. Attach the front Stabilizer (18) to the Main frame (1) with the Allen bolts (20) and Arc
washers (19)
2. Fix the rear Stabilizer (24) to the Main frame (1) with the Allen bolts (25) and Arc washers
(26) as shown.
STEP 2
1. Slip the Protective Guard (13) onto the Handlebar post (11);
2. Connect the lower Sensor wire (14) to the extension Sensor wire (12), and then fix the
Handlebar post (11) on the Main frame (1), using the Allen bolts (7), Spring washers (36), and
Flat washers (15) as shown. Slip down the Mast shield (13) and fit in the place.
To Next Page
Loading...
