2． Loose belts will result in the belt slipping while running, if the belt is too tight it shall decrease the
motor performance and creating more friction between the roller and running belts. The most suitable
tightness of the belts would be: the belts can be pulled out 50-75mm away from the running boards.
3.
Check that all the bolts are tightened after the first training session. Bolts etc should be checked and
tightened reg
ularly as part of the treadmills ongoing maintenance program.
Running belts centering
A
Put the treadmill on a flat ground and have
the treadmill run at 6-8 km/hour to check if
it drifts
If it drifts to the right side, turn adjusting
knob(36) on right side 1/4 circle
clockwisely, check if it drifts. Repeat the
steps above until it centers, see picture A.
B
If it drifts to the left side, turn adjusting
knob(36) on left clockwisely, check if it
drifts. Repeat the steps above until it
centers, see picture B
The running belts will loosen in a certain
amount of time. So to solve this problem,
turn adjusting knob(36) on both side 1/4
circle clockwisely, check if it drifts. Repeat
the steps above until it centers, see
picture C
C
15
To Next Page
Loading...
