○ This is how fast your device speaks to you and reads text. Depending on the
language, reading rates may vary between 80 and 520 words per minute.
● Volume Menu
○ You may set the volume level between 1 and 10, with 1 being the softest setting
and 10 being the loudest setting.
○ You may also set the volume outside of the audio settings menu at any time the
device is awake yet not being used (not in Suspend mode) either using a vocal
command or manually.
■ To increase the volume:
● Rapidly press the trigger button twice and say after the long beep,
“Volume up”.
● Press the plus (“+”) volume button.
■ To decrease the volume:
● Rapidly press the trigger button twice and say after the long beep,
“Volume down”.
● Press the minus (“-”) volume button.
○ OrCam Read will announce when you reach the minimum or maximum volume
level.
● Reading Settings Menu
○ Set Date Format
■ You may change the date format between “month day year”, “day month
year”, and “year month day”. This is to ensure that the device will read
dates properly in texts.
○ Enable or Disable Reading Navigation
■ Reading navigation allows you to skip forward, backward, or pause while
reading. You may enable or disable the feature here.
○ Enable or Disable Beeping when Paused during Reading
■ You may enable or disable beeping sounds when the device is paused
during reading.
○ Set Reading Navigation Pause Time
■ Reading navigation pause time determines how long the reading is
paused before it is cancelled. You may set the reading navigation pause
time to between 30 seconds and 5 minutes.
● Language Settings Menu
○ System Language Menu
■ This is the language in which the device talks to you when making any
system announcements.
■ You may change the system language to any of the installed languages
on your OrCam Read.
○ Reading Language Menu
■ This is the language in which the device reads text to you.
■ You may change the reading language to any of the installed languages
on your OrCam Read.
To Next Page
Loading...