OREC SF600/600D
OPERATION
CAUTION
Check the tightening of bolts, referring to the tightening torque chart
The safety was one of our main worry when designing and manufacturing this machine. Therefore, negligence in
the use of the machine should reduce our efforts to nothing. The prevention strictly depends on the care and on
the skill of the user when applying and maintaining the machine. The best safety method remains a careful and
skilled user ; we wish you to be this kind of user.
The user of this machine is responsible for its safe use. He must be a skilled user specially trained for the use of this
machine. Read the safety instructions. This machine has been designed to mow grass. It is not designed for any other
operation. It is no designed to transport other tools or materials that might damage it and cause injuries to the user. It must
not be used to carry persons.
DANGER
Never use the machine without having priorly carried out all the maintenance operations as described in the daily
maintenance chapter.
CAUTION
Never let children or unskilled persons use the machine. Check that nobody or no object stands near the machine
when at work. They could be hit by the moving parts. Nobody must stand on the machine except the driver. Never
put your hands under moving parts.
STARTING OF THE ENGINE
• Turn the fuel cock "ON".
• Check that the tool and the transmission is disengaged.
• Push choke lever if engine is cold or push throttle lever half if engine is hot. Pull the starter rope. When the engine has
started, pull back the choke lever.
WARNING
Do not travel with the tool rotating.
Working
WARNING
Stop the engine and disconnect the spark plug before clean or perform any maintenance on the machine. Do not
push the rot tiller when the toll is rotating, it may damage the transmission
Working on a soft ground(SF600)(Figure 12-1)
• Start the rototiller.
• Stick the resistance rod in the soil deeply.
• Adjust deep of work as required.
• Select the transmission lever on "A"
• Push and maintain the travel lever.
• To stop working, release the travel lever.
The better speed depends on the hardness of the ground and the depth of work. A
soft ground will be worked at high speed and a hard ground will be worked at low
speed.
Working on a hard ground(SF600)(figure 12-1)
• Start the rototiller.
• Pull up the resistance rod .
• Adjust deep of work as required.
• Select the transmission lever on "B" (figure 11).
Figure 12-1
To Next Page
Loading...