BEFORE YOU BEGIN CLEANING
TO PREVENT DAMAGE TO WOOD FLOORS, FOLLOW MANUFACTURER’S CLEANING RECOMMENDATIONS. IF USING CLEANER ON
SEALED WOOD FLOORS, INSPECT FLOOR SURFACE FOR WORN FINISH, BARE WOOD OR SEPARATED JOINTS. DO NOT USE ORECK
ELITE HARD FLOOR CLEANING SOLUTION TO CLEAN SEALED WOOD FLOORS IF ANY OF THESE CONDITIONS EXIST.
To remove the clean water tank, squeeze
release button and pull to remove.
Please remove any large objects and debris off your floor. It is advisable to then vacuum your floor prior to using your SurfaceScrub
™
.
Important: Only use Oreck Elite Hard Floor Cleaning Solution. Using other solutions may cause excess foaming. Excessive foam
will prevent the machine from working effectively. Using other detergents will invalidate the warranty.
Twist tank cap counter clockwise and lift to
remove.
Using the water tank cap as a measuring cup,
pour in the required amount of solution
(approx. 1 oz. per quart of water).
CAUTION!
To Next Page
Loading...
Need help?
General
