5
WARNING: You must always inspect your
Pistol Grip prior to each use to ensure both
O-Ring seals are present (see figure right).
Do not operate if both O-Rings are not
present. If you attempt to operate the unit
without the O-Rings, there is a risk steam
will escape between the Pistol Grip and the
attachment that may cause scalding.
Filling Your Canister Vapor Cleaner With Water
Step 1: Before filling the Vapor Cleaner, make sure that the unit is NOT plugged in.
Step 2: Turn Safety/Filler Cap counterclockwise to remove. Note: DO NOT
remove the Safety/Filler Cap unless the unit is cool!
Step 3: Using the refill bottle add 1 1/2 quarts of water. Place spout all the way
inside unit until water stops. Push to release flow. Do not overfill.
Replace Filler Cap by turning clockwise - press down firmly to tighten.
Heating time is approximately 5-8 minutes with cold
water.
Step 4: Plug the unit into a standard 120 volt wall (3-prong) grounded
receptacle. The power light will illuminate. Depress On/Off button.
Step 5: Allow approximately 5-8 minutes for vapor unit to reach its working
temperature and pressure. When the working temperature has
been reached, the Green Temperature Ready Light will illumi-
nate and the unit is ready to operate.
Step 6: Connect desired attachments into the Flexible Vapor Hose.
Note: After you start using vapor, the Green Temperature Ready
Light will turn on and off intermittently, indicating that vapor is
being produced. However, vapor can be continuously used.
Step 7: At the start, some water will come out from the nozzle of the attachment.
This is unheated water in the hose and is normal.
IMPORTANT: When the Vapor Cleaner has run out of water, the low-water
thermostat will switch off the unit. The heater will NOT turn on again until
the boiler has cooled or has been refilled with water again.
IMPORTANT: The “On/Off” button only provides power to the Vapor
Generator Heater and the “On” / “Ready” lights. The Handle Vapor Switch
is electronic and receives power directly from the wall plug outlet.
WARNING: When refilling the Vapor Cleaner while it is still hot, the
first drops of water might bubble up. Use caution when opening the
Safety/Filler Cap. Do not open while hot! Leave the unit plugged in,
press the “On/Off” button to “Off”, then depress Handle Switch
only to “On” position and leave “On” for 10 minutes to relieve
Vapor
To Next Page
Loading...
Need help?
General
