Oreck Vacuum Cleaners - Maintenance Procedures; Replacing HEPA Inner Bag; Replacing Worn Belt; Replacing Brushroll

ENGLISH
Maintenance
Replacing Disposable Odor Fighting HEPA Inner Bag
WARNING: Unplug cord from electrical outlet before servicing.
BAG REMOVAL:
Unzip outer bag completely.
Pull bag cardboard collar to release bag dock door from connector. Bag dock door will hinge downward.
Gently pull bag cardboard collar upward out of the bag dock. Saniseal
®
dust seal will close automatically.
BAG INSTALLATION:
Slide the cardboard collar completely onto bag dock door.
Firmly push bag dock door with both thumbs on indication point until it snaps.
8
7
9
10
11
Replacing Worn Belt
WARNING: Unplug cord from electrical outlet before servicing.
Removethedoorbyremovingtheholddownscrewlocatedonsideofpowerhead.
Fold door away from the power head and lift it away.
Removethebeltfromthemotordriveshaftandbrushrollpulley.
Loopthenewbeltoverthebrushrollpulley.Placetheoppositeendofthebeltonthemotordriveshaft.
Replace the door by placing the bottom tab on door into slots located inside power head and pressing the
door closed.
Replace the hold down screw and tighten.
12
13
14
15
16
17
12
13 14 1615
17
6
ENFONCEZ JUSQU’À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN
10
11
7
8 9
Replacing Brushroll
18
19
20
21
WARNING: Unplug cord from electrical outlet before servicing.
YourOreckVacuumhasabrushrollthatcanbereplacedafterheavyuseforimprovedperformance.
Removethebaseplatebyremoving5screws.Then,removethebeltandbrushrollfromthehousing.
Snap the new brushroll into place.
Reassemble the belt.
Reassemble the baseplate.
18 212019