27
Vacuum suction motor
won’t run
• An Auto Reset Thermal Protector has been designed into your cleaner to
protect it from overheating. If activated, your cleaner will stop running. Turn
off cleaner and unplug; let cool for 30 minutes. Replace bag if needed. Check
hose, nozzle, wand and filters for obstructions.
• Thermal Protector
Problem
Power nozzle brushroll
won’t run
Venture
™
Pro Only
ResolutionPossible Cause
• Check hose and hose inlet for clogs. Remove obstruction if necessary.
• Replace bag if full.
• Clean filter if dirty.
• Hose
• Filter Bag
• Filter
• Make sure hose is installed correctly.
• Replace belt if worn or broken.
• Make sure brushroll on/off button is turned on.
• Check brushroll for obstructions.
• See above for “Vacuum suction motor won’t run.”
• Hose
• Belt
• Brushroll on/off button
• Brushroll
• Power nozzle motor protector
Vacuum tools
won’t pick up
To Next Page
Loading...
