Oregon Scientific BAR122HGLA - Display Modes and Indicators; Kinetic Wave Display; Comfort Level Indicators; Remote Sensor Scanning

HOW TO READ THE KINETIC WAVE
DISPLAY
The kinetic wave display shows the signal
main unit. There are three possible forms:
receiving status of the
The unit is in searching mode.
. ^
Transmission data are securely
registered.
No signal received in search mode.
•
REMOTE SENSOR SCANNING
The unit can be set to automatically scan and display readings from
the remote sensors and indoor readings. When the remote-sensor
scanning mode is active, the display will show the readings from
one channel for about 4-second and then proceed to the next channel
To activate the remote-sensor scanning mode:
• Press and hold [CHANNEL] for 2 seconds.
To deactivate the remote-sensor scanning mode:
• Press either [CHANNEL], [MEMORY], [HI/LO], [ A ], [ON/OFF]
_ COMFORT LEVEL IND ICATORS
1116 wmfort level indicators COM, WET or DRY will tell you if the
curent environment is comfortable, too wet or too dry.
a P pear on ^ e display when the following
Indicator
displays
on the unit
Temperature
Range
Flumidity
Range
Shows that the
Current
Environment
©
COM
20°C to 25 °C
(68°F to 77°F)
53
o
o
^
T"-
Ideal range for
both relative
humidity and
temperature
©
WET
-5°C -+ 50°C
1 (23 °F - 122°F)
OVER-
70%RH
Contains excess
moisture.
©
DRY
-5°C -+ 50°C
(23°F - 122°F)
Below
70%RH
Contains
inadequate
moisture
No
Indicator
Less than
20°C( 68°F)
or More than
25°C (77°F)
40%RH
to
70%RH
No comment
(TEMP%RHAL)
7