EN
11
SELECT CHANNEL NUMBER
Press CHANNEL to switch between sensors 1 - 3.
To auto-scan between sensors, press and hold
CHANNEL for 2 seconds. Each sensor's data will be
displayed for 3 seconds. To end auto-scan, press
CHANNEL or MEM.
If you use a sensor that collects only
temperature data, humidity will not be shown.
MINIMUM / MAXIMUM RECORDS
Press MEM to toggle between current, maximum (MAX)
and minimum (MIN) records. To clear the records, press
and hold MEM for 2 seconds. A beep will sound to
confirm that the memory has been cleared.
NOTE
The icon shows the selected sensor.
Designat
ed Display
Remote
Display
Channel 1
Kinetic-
wave Icon
Remote
Display
Channel 2
Remote
Display
Channel 3
NOTE
MOON PHASE
The Calendar must be set for this feature to work.
( 9). Press
or
to view the moon phase for the
next or previous day. Press and hold
or
to scan
quickly through the years (2001 to 2099).
BACKLIGHT
Press SNOOZE / LIGHT to activate the backlight for
8 seconds.
RESET SYSTEM
The RESET buttons are located in the battery
compartments for the main unit and sensors. Press
RESET when you change the batteries and whenever
performance is not behaving as expected (for example,
unable to establish radio frequency link with remote
sensor or Atomic clock).
When you press RESET, all settings will return
to default value, and you will lose all stored information.
SAFETY AND CARE
Clean the product with a slightly damp cloth and alcohol-
free, mild detergent. Avoid dropping the product or
placing it in a high-traffic location.
BAR618HGA lab test R4 2/18/04, 11:26 AM11
To Next Page
Loading...
