11
GB
The BAR898HGA requires entry of elevation in meters not feet.
To convert feet to meters multiply feet by .30.
To determine your location elevation, please either contact
your local library, TV/radio weather forecaster, or via Internet at
http://www.worldatlas.com/aatlas/infopage/elvation.htm.
The atmospheric pressure can be displayed in mb/hPa or inHg.
The pressure unit is selected on the atmospheric pressure slide
switch inside the battery compartment.
If you want to check the pressure history for a particular hour
during the past 24 hours, press the [HISTORY] button. Each
press on the button will go back by an hour. Holding down the
button will increase the value rapidly.
LOW BATTERY INDICATION
When it is time to replace batteries, the respective low battery
indicator [ ] will show up when the corresponding channel is
selected. The battery level of the main unit is shown on the
Weather Forecast Window when it is running low.
HOW TO WALL MOUNT OR USE THE
TABLE STAND (REMOTE UNIT)
As for the remote unit, it comes with a wall-mount holder and a
removable stand. Use either to hold the unit in place.
68°F to 77°F
(20°C to 25°C)
23°F - 122°F
(-5°C -+ 50°C)
23°F - 122°F
(-5°C -+ 50°C)
40%RH-
70%RH
OVER-
70%RH
Below
40%RH
Ideal range for
both relative
humidity and
temperature
Contains excess
moisture
Contains
inadequate
moisture
No
Indicator
Less than
68°F (20°C) or
More than
77°F (25°C)
40%RH
to
70%RH
No comment
HOW TO CHECK
THE BAROMETRIC PRESSURE
The current and historical barometric pressure is shown on the
atmospheric pressure window.
For users staying at a higher altitude such as in the mountain
area, sea-level barometric pressure applies. In this case, press
and hold [HISTORY] button to enter the altitude compensation
setting mode. Use the ALT (
) or ALT ( ) button to select
from -328 feet (-100 meters) to 8,200 feet (2,500 meters)
(whichever appropriate). Press [HISTORY] button to confirm
and exit.
Indicator
displays
on the unit
Temperature
Range
Humidity
Range
Shows the
Current
Environment