Oregon Scientific RMR383HG - Alarm and Temperature;Humidity Settings; Alarm Setup and Control; Temperature Unit and Display

EN
8
2. Press and to change the settings.
3. Press MODE to conrm.
4. The setting sequence is: time zone offset, 12/24 hour
format, hour, minute, year, month, date, and display
language.
NOTE The time zone offset can be used to set the
clock up to + / - 9 hours from the received clock signal
time. If you have disabled the clock signal reception (i.e.
manually setting the clock), do not set a value for time
zone offset.
NOTE The language options are English (E), German
(D), French (F), Italian (I), and Spanish (S).
To switch the clock display:
Press MODE to toggle between:
• Clock with day
• Clock with seconds
ALARM
To set the alarm:
1. Press and hold ALARM for 2 seconds.
2. Press
/ to set alarm time.
3. Press MODE to conrm.
indicates alarm is ON.
To toggle alarms ON / OFF:
1. Press ALARM to display alarm time.
2. Press ALARM again to turn alarm ON / OFF.
To silence the alarm:
• Press SNOOZE to silence it for 8 minutes.
OR
• Press any key except SNOOZE to turn the alarm off
and activate it again after 24 hours.
TEMPERATURE AND HUMIDITY
To toggle temperature unit:
Press °C / °F.
To view outdoor sensors temperature readings:
Press CHANNEL.
To auto-scan between sensors:
Press and hold CHANNEL for 2 seconds. Each sensor’s
data is displayed for 3 seconds.
To end auto-scan:
Press CHANNEL or MEM.
To toggle between current, minimum and maximum
records for the selected sensor:
Press MEM repeatedly.
To clear the records:
Press and hold MEM for 2 seconds.
RMR383HG_M_EN_op1.indd 8 15-9-24 ��2:13