2 remote sensors (THGN500 and THGR122N) are provided
in this package, while 2 more optional wireless remote
sensors can be purchased separately.
Optional wireless remote sensors such as those listed below
can be purchased separately:
- THGR122N / THGN122N
- THGN132N
- THGR228N / THGN228N
- THGR238N / THGN238N
To set up the remote sensor:
1. Open the battery compartment and insert batteries,
matching the polarity.
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the remote sensor within 30 m (98 ft) from the
main unit.
NOTE Use alkaline batteries for longer usage and consumer
grade lithium batteries in temperatures below freezing.
To search for a sensor:
Press and hold + at the same time.
The remote sensor reception icon will show the following
status:
ICON DESCRIPTION
Main unit is searching
for sensor(s).
A channel has been
found.
The sensor cannot be
found.
TIP The transmission range may vary depending on many
factors. You may need to experiment with various locations
to get the best results.
CLOCK AND CALENDAR
NOTE If optional sensors are installed:
• clock and calendar display will be replaced by
temperature/humidity readings.
• press to toggle between clock and temperature/
humidity display, or calendar and temperature/humidity
display.
CLOCK RECEPTION
This product is designed to synchronize its clock
automatically with a clock signal.
RMR500ES:
EU: DCF-77 signal: within 1 500 km (932 miles) of Frankfurt,
Germany.
To Next Page
Loading...
Need help?
General
