Oregon Scientific RMR683HG - Sensor Data Transmission; Clock Functions; Clock Reception and Synchronization; Manual Clock Setting

EN
7
SENSOR DATA TRANSMISSION
The sensor reception icon in the temperature and
humidity area shows the status.
I
CO
N DESCRIPTION
Main unit is searching for the
se
nsor(s)
A channel has been found
and sensor signal is being
receive
d
and “- - . -“
The sensor cannot be found.
(Temperature Search for the sensor or
and Humidity Area) check batteries
To
search for a sensor:
Simultaneously, press and hold
MEM
and
CHANNEL
for 2 seconds.
NOTE
If the sensor is still not found, check the batteries,
If the sensor is still not found, check the batteries,
obstructions, and remote unit location.
N DESCRIPTION
Main unit is searching for the
se
and sensor signal is being
receive
The sensor cannot be found.
(Temperature Search for the sensor or
and Humidity Area) check batteries
RECEPTION SIGNAL
Clock signal reception indicator:
STRONG SIGNAL
WEAK SIGNAL NO SIGNAL
STRONG SIGNAL WEAK SIGNAL NO SIGNALSTRONG SIGNAL
To enable and force a signal search:
Press and hold
for 2 seconds.
To dis
able the signal reception:
Pre
ss and hold
for 2 seconds.
SET CLOCK
If the clock signal reception is enabled and a signal is
being received the clock does not need to be manually
set.
To manually set the clock:
1. Press and hold
MODE
for 2 seconds.
WEAK SIGNAL NO SIGNAL
WEAK SIGNAL NO SIGNAL
CLOCK
CLOCK RECEPTION
This product is designed to synchronize its date and time
automatically once it is within range of :
• DCF77 generated from Frankfurt, Germany for
Central Europe.
• MSF60
generated from Rugby, England.
The clock collects the radio signals whenever it is within
1500 km (932 miles) of a signal.
NOTE
Slide the
Slide the
EU / UK
switch to appropriate position
for your location. Repeat each time you reset the unit.
NOTE
Initial reception takes 2-10 minutes for fi rst set
Initial reception takes 2-10 minutes for fi rst set
up or when
RESET
is pressed. Once complete, the
reception icon will stop blinking. If the signal is weak, it
can take up to 24 hours to get a valid signal.
RMR683HG_M_EN_RC3.indd 7 2006.5.26 11:11:15 AM